Blog / Flooring
Canadian Standard Flooring Review (2026)
An installer’s look at Canadian Standard: 43 Brand Surfaces engineered floors, 26 Vanntett and Evion 9 vinyl planks and one solid maple, from the spec sheets.

Quick answer
- Where the numbers come from
- The range side by side
- Vanntett and Evion 9 are built differently
- Brand Surfaces: floating or fastened comes first
- Keep the hardwood out of the basement until we confirm
- What to check before you buy
- What it costs installed
- Buying Canadian Standard flooring in Toronto
- Every Canadian Standard floor we carry
- Frequently asked questions
Where the numbers come from
Every figure below comes from the spec sheets of the 70 Canadian Standard floors on our site as of November 2026. Where a sheet does not state something, we say so rather than fill the gap. We have not run our own wear tests and we do not give star ratings.
The range side by side
Vanntett and Evion 9 are built differently
The 26 vinyl floors are not one product in three colourways. Vanntett Plus and Vanntett Pro are SPC planks with a 0.5mm (20mil) wear layer, micro-bevelled edges and a matte EIR surface, where the texture follows the printed grain. Evion 9 is a WPC rigid-core plank, 9mm thick, with a 0.55mm (22mil) wear layer, painted bevels and an antibacterial cork backing fixed to the plank.
In plain terms, a stone-based SPC core is dense and shrugs off dents from chair legs and dropped pots. A WPC core is a little softer and warmer underfoot, and the cork backing makes Evion 9 quieter to walk on. In a condo, that attached backing is worth showing to your building before you buy, since many boards have their own sound rules.
Vanntett Pro carries an IXPE backing on the plank; the Vanntett Plus sheets list no attached underlayment, so plan on a separate pad there.
Brand Surfaces: floating or fastened comes first
All 43 Brand Surfaces floors are engineered, and the sheets split them by installation: 25 float and 18 are glued, nailed or stapled. Thickness runs ⅜″, ½″ or ¾″, and the finish is wire brushed on 30 sheets and handscraped and wire brushed on 7. That textured surface hides scuffs and paw marks far better than a smooth one, which matters with kids and dogs.
A floating board is the natural fit for a condo slab or a room where you cannot nail down. A fastened ¾″ board feels more like solid wood underfoot and is the better match for stairs and older houses with a plywood subfloor.
Thickness also decides your doorways. A ⅜″ floor meets tile and closet doors more easily than a ¾″ one. The sheets we hold do not state in-floor heat compatibility, so if you have radiant heat we confirm that with the specific floor before quoting.
Keep the hardwood out of the basement until we confirm
Every Brand Surfaces sheet is rated on or above grade, and Kingsport, the solid maple, is the same. A Toronto basement is below grade, with a slab that breathes moisture through the year, so we do not treat any of the wood floors here as a basement floor. If you want wood downstairs, ask us to confirm the grade rating for that floor first.
The vinyl is the safer basement choice. Evion 9 is rated on, above or below grade, and its 5G Välinge DRY joint is built to keep water out of the seams. Kingsport, at ¾″ thick and 4¾″ wide, can be sanded and refinished several times, which makes it a main-floor and upper-storey floor rather than a basement one.
What to check before you buy
The grade rating. Brand Surfaces and Kingsport are rated on or above grade, so confirm with us before planning any wood floor for a basement.
Thickness at your doorways. Engineered boards run ⅜″, ½″ or ¾″ and the vinyl from 5.2 mm to 9mm, which changes transitions, door clearance and stair nosings.
Which vinyl warranty applies. Eighteen vinyl sheets carry 50-yr residential / 10-yr commercial and eight carry 25-yr residential / 5-yr light commercial, so check the line on the floor you pick.
What it costs installed
Click vinyl is from $3.20 per square foot, engineered hardwood from $4.90 nailed or glued, including glue and nails, or $3.20 floating, and solid hardwood from $4.50. This is installation only; the floor itself, disposal, trim and levelling are priced on top, and the full list is on our flooring installation cost page. For how we install it, see our page on hardwood flooring installation in Toronto.
Browse Canadian Standard in our shop: engineered hardwood, vinyl and solid hardwood. Send us your square footage for a free quote.
Typical of the range: Yara Evion 9, Parisian House Brand Surfaces and Kingsport Brand Coverings.
Doing the stairs at the same time? See our staircase renovation in Toronto, about $7,000 a flight.
Buying Canadian Standard flooring in Toronto
We carry Canadian Standard in vinyl and solid and engineered hardwood and install it across Toronto and the GTA. Our installers travel as far as Wasaga Beach, Niagara Falls and Castleton. Send your square footage for a free written quote, or book the free in-home measure and we will bring samples.
Every Canadian Standard floor we carry
All 70 Canadian Standard floors on our site, by collection. Tap a collection to see it as a group, or a colour to open that floor.
Engineered hardwood
Solid hardwood
Vinyl
Frequently asked questions
Is Canadian Standard vinyl waterproof?
The Evion 9 sheets list it as waterproof, on a WPC rigid core rated on, above or below grade. The Vanntett sheets in our data do not carry a water-resistance line or an AC rating, but they give a 0.5mm (20mil) wear layer. Ask us for the water claim on the exact Vanntett floor you like.
Can Brand Surfaces engineered hardwood go in a basement?
All 43 Brand Surfaces sheets are rated on or above grade, and sources disagree on below-grade use. We do not recommend planning one for a basement until we have confirmed the grade rating with you. Evion 9 vinyl is rated below grade and is the safer choice there.
What is the difference between Vanntett Plus and Vanntett Pro?
Vanntett Plus is a 9″ × 60″ × 7 mm plank, 6 to a carton covering 22.09 sq. ft. / box. Vanntett Pro is 7″ × 48″ × 5.2 mm with an IXPE backing, 10 planks covering 23.65 sq. ft. / box. Both have micro-bevelled edges, a matte finish and EIR texture.
Is Canadian Standard hardwood solid or engineered?
Almost all of it is engineered: the 43 Brand Surfaces floors in oak, maple and hickory. The one solid floor is Kingsport in the Brand Coverings collection, solid maple in ¾″ boards 4¾″ wide that nail, staple or glue over a wood subfloor.
What warranty does Canadian Standard give?
Brand Surfaces engineered hardwood carries a 25-yr residential warranty on every sheet, and Kingsport a 25-year residential warranty. On the vinyl, 18 sheets carry 50-yr residential / 10-yr commercial and 8 carry 25-yr residential / 5-yr light commercial.
Keep reading

























